Hi All,

Love the customisable Meters!!

Although I think I found a bug with puresignal. If I transmit in CW and change back to SSB puresignal no longer functions. I have to re start thetis for it to work.

I am using an Anan10 with protocol 2. A friend of mine using the Anan 7000dle has reported ...

The motherboard is a Gigabyte Z690 Aorus Elite which has a Realtek® 2.5GbE LAN chip (2.5 Gbps / 1 Gbps / 100 Mbps).

I have both the PC and the radio going into a Cisco gigabit switch.

It's was a complete upgrade.
CPU, motherboard and ram.
I am running windows 11.

The Old system was an i7-6700.

I'm suspecting it may have something to do with the onboard network card.

I have been using thetis 2.9.0.6 for a few months now and has been working well.

Today I upgraded my PC to the latest generation. I7-12700. After the install I turned on my new PC but unfortunately I was unable to connect to the radio. It seems when I click the power button it connects to the radio ...

This is just an update to my earlier post, after much fussing about, I have figured out the issue with no predistorion correction.

Initially, I assumed the problem was within the software or firmware. So ended up testing the same setup with a different amplifier and it worked.
After this test, I ...

My setup.
Anan 10. 10.8pre20
Thetis 2.8.11 21f
1.5kw ldmos amplifier.
-55db coupler.

İ seem to be having an issue getting pure signal to work with this setup. Turning on or off pre distortion only makes a marginal improvement to the Imd please see the photos.

One thing I did notice is that there ...

Hi Rick,
I've tested the new firmware this morning.
The ADC 2 warning has stopped flashing.
Everything seems to be working normal.
Did some tests with PS. PS is now functional up to 192khz.
When i change it to 384khz it still seems to be working but the panadapter seems to slow down also the tx ...

İ can confirm that ADC 2 is flashing continuously.


Regards Onder

Hi all,
I have installed the latest version of the protocol 2 firmware for my ANAN10e, using the latest Thetis 2.6.7.
Everything seems to work perfectly except for Pure signal.
When I activate PS it seems to make the firmware crash after a little while, which needs the radio power cycled to recover ...