Any idea as to when you will release the new meter version??

Found out that it has to do with what rbf file you are running. I was using Hermes_Protocol_2_v10.3.rbf and was getting that issue I went to 10.8 pre 20 and swr reading is correct

Mine shows high swr in any mode and in tune . . . Always shows the 26:1

Is there any calibration for the swr on the ANAN 10. Mine always shows 26:1 dummy load shows 1:1 with external meter.

Stupid Question . . .

I purchased a 7" touch screen and case for my Pi3. Was wondering how do i get the piHPSDR program to show full screen on it . It is now like at 70% screen.

Still working 100% on P2


Still working . . . Only had 1 burp

Thanks . . . I will check that out . . . What I also did was install a version of Protocol 2 which limits the lan speed to 100 mbps Hermes_Protocol_2_v10.3 firmware.

So far so good . . . Been running for an hour now . . . We'll keep the fingers crossed.

Will this latest card from Apache Labs work with protocol 2

Open HPSDR Hermes (14 bit ADC, EP3C25) Transceiver Card (Assembled & Tested . . . Gonna replace the one in the ANAN 10

but what happens is Thetis stops and the power light on the radio fades from off to dim and I have to turn off radio and restart thetis.

I just put the latest protocol 2 back on there and I saw the error pop up but the radio and Thetis kept running. Then it popped up again and stopped.

I tried all the different P2 firmware updates on the link you posted here. Thought it was thermal at first but even tried it from a stone cold unit after letting it sit for a few hours.

Where do I find s/n . . . Mac is C0-A8-64-BA-0-01

Had no audio dropouts at all.

Well after running protocol 2 for a day and a half . . . which I really liked . . .

Started getting Sequence Error 259 DDC1 mic

Had to go back to Protocol 1

Is there thermal protection in the ANAN 10. Was runing a little FT-8 to set it up and after 5 minutes or so it shut down with a fading power light.

Updated and so far all is well

I found the info

Being fairly new to this what program do I use to flash the firmware??

Can the Anan 10 be flashed with the Protocol 2 Firmware so I can run it with SDR Console??

Thank you all very much . . . That is what I was looking for WOO . . . HOO

Is there any way in Thetis to have the pan adapter in fixed mode so when I tune the pan adapter stays in the same place instead of it being in center mode

I am running a Anan 7000dle with protocol 2 and SDR Console v3.0.23. I have 4 receivers brought up. one on 40m, 2 on 80m, one on 20m to monitor my favorite frequencies. When I select the 40m receiver the other 3 are blank. It appears the bandwidth is not wide enough to receive 80,40,20 at the same t...