I'm making a polite request here because I haven't received an answer from Apache Support for a long time. My emails are not being answered. I ordered a HPSDR Hermes and a 10W PA Board for Hermes a long time ago. The HPSDR Hermes board was also delivered, but the 10W PA was still missing. Why isn't ...

Verkaufe neue kürzlich von Apache Labs gelieferte

„Open HPSDR Hermes Transceiver Card“ in Originalverpackung mit Garantie

Hermes = 389,00 USD
Shipping = 70,00 USD

510€ incl. Versand

Hermes befindet sich in DL 74245 und kann sofort versendet oder abgeholt werden.

73 DG1LT

Hello Norbert,

then everything is as it should be, device has been successfully repaired. Thank you again for your assistance with troubleshooting.

I still have some current sensors here in case anyone needs it.

73 Thoren

Hello Norbert,

I finally got the current sensor and installed it. What I notice is that the Anan only shows 0.1 A at 13.6 V in RX mode. With TX FM, 12.7 V voltage dip with 95W approx. 12.5 A. If these values are OK, I suspected that the sensor delivers more precise values.

73 Thoren

the 30 amp type is installed...

Hello Norbert, the ACS713 is defective. Pin 7 is 0.35V in RX operation and 0.62V in 45W TX. If I apply 5V to R91, the Thetis will display 53A. If the ACS713 is a 20A or 30A version, I can only see ACS713T. Do you know a fast source of supply with cheap shipping. Thank you in advance for your good he...

I'm curious what is broken. I inserted the 10 pin cable incorrectly.
J15 Orion on J22 PA
J10 Ext. To J7 PA
That was wrong, the U17 (ADC78H90CIMT) on the Orion Board is already new.
What is still broken now?

Hello Norbert,

at the weekend I will disassemble the device, thank you very much for your information.

73 Thoren

Hello Norbert,

unfortunately not, I can't find the place where the current is measured (ampere).
It must be on the PA board. The Thetis always shows 0.0 amperes.

73 Thoren[img][/img]

Hi there, when repairing my Anan700DLE, I had a defective U17 (ADC78H90CIMT) on the Orion board. During assembly, I plugged the Orion ribbon cable into the wrong connector on the PA board. J17 is correct, I stuck to J22. The V (volt) indicator and the FWD_PWR and REV_PWR are fine with the new ADC78H...