Yes I did try a direct connect without sucess ! Can anyone one answer me the following questions : ? Because this began after successful flashing of firmware in the Anan 100 and shortly verifying that the new s_v3.2.rbf file using HPSD BOOT 2.0. would run Thetis software and the Anan 100 appeared to...

I think I mentioned that the lights blink. Power lights remain on on both ends (left light ) (right light) constantly blinks . winpcap was loaded each time ... Also tried NPCAP removing WinPCap first and then installing NPCAP. The activity light constantly blinks on both ends .

You can't just throw code at it if the test for bootloader fails. Does BOTH the PC and ANAN NIC lights show a link status? Yes but I am not sure what you mean about Link status ? Left = Power light is on Right light blinks .... Does Windows show a valid link on that NIC, and show speed to be 100Mbit...

Forgot to mention that none of the lights near the FPGA Altera Cyclone are lit D10-D19 Are OFF - Not LIT

Per your instructions : no success Direct Connect from Computer to ANAN ... Nic Lights Left solid right blink ... J12 jumpered. D6 = status light stays on ... boot loader does nothing when test for bootloader is selected ... Tried putting in hermes _v3.3.rbt in the board programmer box and pressing ...

It does Not see the the Anan anywhere. It was on the 10.0.0.X network I swept the entire range 10.0.0.1 to 10.0.0.255 Nothing there. Think that it might have defaulted to a 192.168.0.1 to 192.168.0.255 network node swept that also ... All connections done both through a router and directly from the ...

In an effort to upgrade my Anan 100 to work with SDR Console 3.0 Beta ( which requires protocol 2) I flashed the firmware with Hermes_v3.3.rbf file using HPSD BOOT 2.0. All work well at this point ... was able to load and configure Thetis. Looked all was working perfectly however I was still unable ...