Scott, Thanks for your thoughts. You confirmed my thoughts. I don't have appropriate test equipment but will put the scope on the coupler tap to confirm that level. PS is working well, I could just not worry about it but that's not my nature HI HI. Do you know what the coupling factor is for the int...

Scott, It's been a long time but I now have the LP-100A in place. Before ordering the wattmeter, I discussed the coupler tap with Larry and requested -47 dB output. I'm confident that's what I have but have not actually measured the output. I may need to do that. I ordered -47 instead of -50 because...

Scott, Thanks for the reply and advice. Pure Signal with just the radio performs admirably. I'll go ahead and order the wattmeter with the special coupler that provides the additional -50dB output. In case anyone ever reads this, the wattmeter is an LP-100A that has an optional coupler incorporating...

Scott, I understand the calculations at the beginning of this thread. I'm in the process of buying a wattmeter and have the option of a coupler with an additional -50dB port for PS. My radio is a 7000DLE MKIII. Here's my dilemma. I assume my radio has a 14dB pre-amp before the ADC. Working backwards...

Rick,

Since I posted the original observation, I'd be happy to help out. Test equipment and knowledge is limited though. I have a 5CEFA MkIII.

Thanks,

Tom - NS8K

Whew, what a relief! Many thanks to Chris, Sam, Scott and especially Rick. Looking forward to the updated firmware. Now, I can move off of QSK and continue setup. I'll definitely sleep better tonight!

Tnx es 73,

Tom

I'm at my wit's end with this, trying to figure out if I have a hardware, software, firmware or ordinary cockpit problem here. The radio is a 7000 Mk3 that was received from India on 2/7/23. It came with Firmware Ver 2.1.7 installed and is on Protocol 2 (v3.9). Thetis was at Ver 2.9.0.3 and I upgrad...

Tim, I know this thread is dated but I had the same desire as you, connect a K1EL Winkeyer to the front panel key jack. It didn't work. The solution turned out to be rather simple. First, the cable. The output of the WinKeyer is an RCA jack. Center pin is the keying signal, shield is ground. The oth...

Hello to all. I just received my 7000 MkIII a few days ago. Very new to this. I have discovered that when I select QSK, I have no RF output. If I switch to Semi, output is fine. I have the custom AGC settings as described in the manual and various posts. I've not found a setting that relates to this...