I wonder if anyone else is seeing this. Using latest Dev2 and setting Rx antenna to either Antenna port 2 or 3 with Port 1 set as transmit, I can not get QSK to select when in CW mode. I only get Off and Semi. If I change the Rx port from port 2 or 3 and select EXT1, I can once again select QSK mode...

"The problem is that I can not Loading firmware with the bootloader." When your Anan is switched to bootloader mode does the green light to the left of the Ethernet cable on the radio turn on solid when you power the radio on? If not, check the following: Right click the Windows start butt...

Robert, you may have already tried this but if not give it a go. Save your current database then reset the database and shutdown Thetis. Power cycle the radio then start Thetis. Put just the bare minimum setup info in to get the radio operating and then try the calibration routine again and see if a...

Robert, I assume you have tried adjusting the adjustment that is just below the option "Using ext 10Mhz ref" and not the "Correction Factor" adjustment when you have the GDO connected? I have a 7000 MK II and I use a GDO and have no trouble moving the "zero" around with...

I just tested Richies latest Dev work and it indeed seems to be recording MIC audio now. A good test is to do a quick recording on one band, play it back to verify it, then switch to another band to see if it still plays. It does thus it couldn't be an IQ recording.

Thanks Richie!

Joe