also just to mention that on my G2 using Thetis v2.10.3.6 setup / general shows Firmware version 2.0.0 Id: Saturn Protocol 2 (v3.9) So dumb question , how does this relate to the latest firware version ? In other words I should see Saturn Protocol 2 (v12) when updated or is this not reference to th...

gw0hyu wrote:I notice saturnprimary2023V13.bin is loaded up on github, is this good to load on G2 without front ?

Cheers
Keith

Just read the release notes , so guess the answer is no for now.. ..

also just to mention that on my G2 using Thetis v2.10.3.6 setup / general shows Firmware version 2.0.0 Id: Saturn Protocol 2 (v3.9) So dumb question , how does this relate to the latest firware version ? In other words I should see Saturn Protocol 2 (v12) when updated or is this not reference to the...

I notice saturnprimary2023V13.bin is loaded up on github, is this good to load on G2 without front ?

Cheers
Keith

The codec is a TLV320AIC23B. We know that it will need to be replaced eventually but there is no short term need. Its line inputs are tracked directly to the Line in 3.5mm connector on the rear panel. The differential preamp is on a separate small board, and feeds into the codec microphone input vi...

This is based on the circuit design being comprised of an NE5534 op amp in differential, non-inverting, single supply configuration and having a gain of 10. This is followed by a TLV320AIC3204 CODEC chip. This is significantly different than the TLV320AIC23B used in previous ANAN designs. The 3204 ...

Hi all, Can anybody confirm that that G2 has the TLV320AIC3204 codec implemented , and where on the PCB, and whether there is a direct jump point to pick up the line in pins e.g 13,14,15,16 . I cant seem to find any G2 circuit diagrams available. Looking at the physical board maybe J56 facilitates a...

Thanks very much for that info Bryan. Not good from my point of view though. Think I'll stick as I am with cables hard wired from my interface to the line in and speakers out on the Anan. Terry. GW4NNO Hi Terry, Have you explored setting Thetis to use Windows WASPI driver with your RME UFX ( I also...