A few months ago, I took a second look at the CMD Studio as i really appreciated its size, feel of the wheels and potential of control it could provide.
What i found with respect to programming the wheels was it mattered if you programed them on the 0 or 127 reading. all works great now and the
few ...

I agree. that's really the issue - 4K monitors. Maybe in what of the newer iterations
Wonderful insightful things have been added. The work around for me is placing the
list in an adjacent monitor that assist my aging eyes with it resolution.

Thank you for your reply Scott. Your reply had me checking my work. I took the 0 127 from the Starlight device I have.

When I looked again at the 2A controller, upon hitting the button the values are 127 127.

I am looking to see if I can increase the font size in the memory channel interface.

Any suggestions?

Thank you,

Joe

Picked up the CMD Studio 2a controller. The sliders worked immediately, on to the wheels. With the help of this forum, downloaded the driver and the wheels work smoothly My unresolved issue is getting the buttons to work. The show up as 0 and 127 when pressed. The diagnosis shows as on an off as the ...

Hello Rick,
Thank you for taking the tine to point out something, that should have been obvious. Or at least tried before writing the request.
I appreciate it,

Joe N9EMC

I am new both to the Anan G2 and the Thetis software. Very happy with both. I am trying to find away to arrange the random memory channels I have entered to make them easier to access. Ideally by frequency or type. Is there a file in Thetis I can access to move these entries about?

Thank you,

Joe ...