W4WMT wrote:StefanoAlvaro wrote:Could it be that the cmASIO functionality only works with protocol2?
Hi OM,
Yes, that is correct, cmASIO is not supported by protocol_1.
I'll have to check why the icon is still green using protocol 1 (I thought we tested that).
As far as not being able to run protocol_2 on your MKIII, have you checked out all of Rick's N1GP firmware builds for that FPGA? He has quite a few, you might get lucky!
73,
Bryan
Thanks Bryan, I imagined it was like this because with the same procedure on the p2 everything worked immediately.. Patience.
Regarding the fw there is nothing yet for my 5CEFA, only one works well at the beginning (21.7) but after a few minutes of TX it starts to give problems, regardless of the temperature.
Is there a possibility of operation in the future with the p1 and cmASIO?