Unless and until a software fix in Thetis can be implemented, anyone with a new ANAN-7000 with a serial number ending in "A" will not be able to obtain correct current readings in Thetis.
The reason for this is Apache chose to replace the ACS713-30A current sensor on the RF board with the TMCS1100A2 due to part obsolescence. This has the unfortunate effect of causing all current readings to be low by a factor of 0.55, i.e. 2 amps will read as 1.1
Current readings on new ANAN-7000's with serial numbers ending in "A"
Re: Current readings on new ANAN-7000's with serial numbers ending in "A"
Thanks for the information. If I could get any current reading at all that would be great, but I believe all the "a" models delivered since 7/1 have 0 current shown in Thetis. On the P1 firmware at least voltage was shown, but using P2 voltage behavior gets really erroneous swinging wildly from 13V to 30V during transmit.
Return to “Everything Else: Antennas, Relays, Switches, Power, Grounding, Cooling, etc.”