Question on "Being Current" with My Anan 7000DLE MkII

[tcrothers57]

Hi Everyone,

This morning I upgraded to Thetis V2.10.3.6 X64 on my 7000DLE MkII.

After I did that, I wondered if maybe I ought to upgrade my firmware (since it's been awhile since my last FW upgrade). I looked online a bit to find P2 version 2.1.18 available for download.

I have now successfully updated my 7000DLE MkII to P2 version 2.1.18
So far I'm running the new Thetis V2.10.3.6 X64 without issue.

I'm pretty sure the version of Thetis I'm running now is the most current. I'm wondering though - Is P2 version 2.1.18 the most current?

Thanks,

Tom
W8NA
Westerville, OH

[n1gp]

Hi Tom,

This is the latest thread on firmware:
viewtopic.php?f=32&t=4972


You'll probably want to download and install:
https://www.dropbox.com/scl/fi/vvk1c16q ... 6w2lu&dl=0

-Rick / N1GP

[tcrothers57]

Thanks Rick,

I have downloaded and installed P2 version 2.2.2 Initial testing yields no obvious problems.

Upon further reading online, I learned of the possible issue with RF on receive only antenna ports/connections within my 7000DLE. I'll do testing to determine if I have an "all clear" on that issue.

Should I expect that all will be well/resolved with this issue now that I'm running Thetis v2.10.3.6 and Protocol 2 v 2.2.2 ?

If I understand my reading, it looks like this issue may have been resolved with the aforementioned SW and FW upgrades ( as told and written up by those individuals who tested for this issue).

Please tell me if I am mistaken.

Thanks so much and 73,

Tom

[I2NOY]

I think you are right and I have same hardware, firmware and software.
Rick has by sure final answer.