10E Protocol2 Open collectors not working.
Posted: Mon May 11, 2020 6:06 pm
Hi,
I had installed the new firmware, everything works fine, but the open collector output for driving my linear amp is not working (OC Control ). no response on selection inside thetis.
I reverted it back to protocol 1 it is working well.
Kindly confirm, is this option not supported in the protocol2 firmware? or I have to
change some other settings in thetis software?
requesting help, else I have to stay with my old firmware.
73's
Praveen, VU3PRW
I had installed the new firmware, everything works fine, but the open collector output for driving my linear amp is not working (OC Control ). no response on selection inside thetis.
I reverted it back to protocol 1 it is working well.
Kindly confirm, is this option not supported in the protocol2 firmware? or I have to
change some other settings in thetis software?
requesting help, else I have to stay with my old firmware.
73's
Praveen, VU3PRW