Open HPSDR 14-Bit Hermes received 2 weeks ago
Posted: Sat Mar 25, 2023 11:19 pm
I received HPSDR 14-Bit Hermes board. It came with firmware ver. 1.5.
Using boot loader I setup IP address, no problem here.
Thetis 2.9.0.6 recognized the board, however while antenna connected to RX port no signal was displayed on spectrum.
Tried PowerSDR mRX PS ver. 3.4.9 with the same result, the Hermes board was recognized but no signal on PowerSDR spectrum.
I verified that the antenna works with my other working Hermes/Alex transceiver.
I decided upgrading Hermes firmware to ver. 3.3, same as I used on my old working Hermes board. Unfortunately after upgrade Hermes stopped working. The LED which is flashing while Hermes is working is just steady on.
Downgraded Hermes firmware to 2.3, it did not helped. The board is still not working.
Any help would be very much appreciated.
Adam, AC8CE
Using boot loader I setup IP address, no problem here.
Thetis 2.9.0.6 recognized the board, however while antenna connected to RX port no signal was displayed on spectrum.
Tried PowerSDR mRX PS ver. 3.4.9 with the same result, the Hermes board was recognized but no signal on PowerSDR spectrum.
I verified that the antenna works with my other working Hermes/Alex transceiver.
I decided upgrading Hermes firmware to ver. 3.3, same as I used on my old working Hermes board. Unfortunately after upgrade Hermes stopped working. The LED which is flashing while Hermes is working is just steady on.
Downgraded Hermes firmware to 2.3, it did not helped. The board is still not working.
Any help would be very much appreciated.
Adam, AC8CE