Hello,
tested with Thetis 2.6.2, very common Seq => 1,10,14,40,41 error, with activated 2RX Seq => 56,57,59.
When Seq appears, the LAN transmission stops for a short time.
If TX, SSB, without audio display 1-2mW TX power on powersdr.
Alex SPI Word incorrect, e.g. TX-> 2RX to GND without function, other not yet tested.
my HW:
first pc:
-TR4 1950X
-designare
-128gb ram
second pc (only for sdr):
- i7 4790
-16gb ram
-ecs itx pro board
last tested with Notebook Dell M4800 (i7 4810mq, 32gb RAM), always the same results…
best regards René
Experience FW1.3 on Orion MKII
Forum rules
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.