Just for kicks, I went to v2.2.1 Protocol 2 version and while it is too early to tell, it seems like I am getting larger over/underflow numbers than when I was on v.2.1.18 Protocol 2. Also, I am hearing audio drop-outs on receive (not sure if the same is true on transmit at this point) which were not there before. These drop-outs occur every 1-3 minutes or so.
Before trying v.2.2.2 Protocol 2 version, I am wondering if there is a Thetis version that may be more "compatible" with either of these P2 versions? My Thetis version currently is: Thetis v2.10.4.3 x64
The FPGA in my 7000 DLEMKII is: EP4CGX150F896 Cyclone IV series FPGA
Any comments on the "compatibility" aspect?
Juha
UPDATE:Upgraded to v2.2.2 which seems much better than v.2.2.1 (at least based on the absence of audio drop-outs on receive) this morning.
Compatibility of Thetis versions with Protocol 2 versions
Forum rules
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Compatibility of Thetis versions with Protocol 2 versions
PC: 8 Core i7-10700 CPU @ 2.90GHz, NVMe SK Hynix 512 GB SSD, 32GB RAM
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.2.2
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.2.2