Today I updated Thethis to version 2.10.3.6 x63 and (FW v.2.00 Protocol 2) dev_2. I now have no transmitter output power. Has anyone had such a problem?
Slawomir
No TX output power
-
- Posts: 227
- Joined: Mon Nov 11, 2019 7:39 pm
Re: No TX output power
There will be another Thetis release that's associated with the code change to prevent CW TX on an antenna selected for RX. Rick and I worked out what needed to happen and Rick has committed an update but a new release hasn't yet been generated. The solution to that has been a long journey with protocol changes, firmware changes, piHPSDR and Thetis changes. That could be responsible.
What mode are you using? If CW, press MOX on and off after a band change and see if that makes a difference.
And what client app are you using? This issue was resolved in piHPSDR some time ago.
What mode are you using? If CW, press MOX on and off after a band change and see if that makes a difference.
And what client app are you using? This issue was resolved in piHPSDR some time ago.
Laurence Barker G8NJJ
-
- Posts: 227
- Joined: Mon Nov 11, 2019 7:39 pm
Re: No TX output power
qst wrote:Today I updated Thethis to version 2.10.3.6 x63 and (FW v.2.00 Protocol 2) dev_2. I now have no transmitter output power. Has anyone had such a problem?
Slawomir
FW v.2.00 Protocol 2) dev_2? Isn't that a firmware release for a non-G2 radio?
Laurence Barker G8NJJ
Re: No TX output power
laurencebarker wrote:qst wrote:Today I updated Thethis to version 2.10.3.6 x63 and (FW v.2.00 Protocol 2) dev_2. I now have no transmitter output power. Has anyone had such a problem?
Slawomir
FW v.2.00 Protocol 2) dev_2? Isn't that a firmware release for a non-G2 radio?
I believe it's the fw version that can be seen on the window title bar. Thetis, controling my G2, shows exactly the same version no.
73, Norbert - DL8LAQ - ANAN-G2 w/display - Richie's latest Thetis version and pihpsdr by N1GP&DL1YCF
Re: No TX output power
Sorry for the mistake. My Tethis version is v.2.10.3.6x64 (01/28/24)dev_2. I don't know why it appears as Hermes in the Firmware setup. I installed the saturnprimary.bin file and got the output back. I haven't tried CW yet. I'll check it out today.
Slawomir
Slawomir