I've not been on the air for some time and would like to get things going again.
I have a ANAN 100D and had version 3.2.25 in my PC before my PC crashed.
Now that I have to be reloading things I'm wondering just what to install.
TNX
Getting back on the air
-
- Posts: 3
- Joined: Tue Apr 11, 2017 11:33 am
Re: Getting back on the air
Welcome back! Your best course would be to move to Thetis v2.8.11 which is the latest release. It's light-years ahead of the last PowerSDR mRX PS release which appears to be at end-of-life as far as any further development goes.
Thetis version 2.8.11 will work with either protocol 1 or protocol 2 and will automatically load the appropriate code for whatever firmware is loaded into your hardware. The download link is here:
https://github.com/TAPR/OpenHPSDR-Thetis/releases/tag/v2.8.11
The only decision to make is whether the 32-bit or 64-bit version is most appropriate for your operating system.
Good luck and 73,
Rob W1AEX
Thetis version 2.8.11 will work with either protocol 1 or protocol 2 and will automatically load the appropriate code for whatever firmware is loaded into your hardware. The download link is here:
https://github.com/TAPR/OpenHPSDR-Thetis/releases/tag/v2.8.11
The only decision to make is whether the 32-bit or 64-bit version is most appropriate for your operating system.
Good luck and 73,
Rob W1AEX
"One thing I am certain of is that there is too much certainty in the world."
-
- Posts: 3
- Joined: Tue Apr 11, 2017 11:33 am
Re: Getting back on the air
OK ..............
THANKS !!!
I'll move over to the Thetis section.
THANKS !!!
I'll move over to the Thetis section.