Page 1 of 1
New Protocol
Posted: Mon Apr 17, 2017 8:05 am
by Simon
Woo-Hoo,
I've been testing the new firmware (not publicly available) and had a long QSO on 80m using VOX which was hammering the areas where before there had been issues.
it ran very nicely
.
Re: New Protocol
Posted: Mon Apr 17, 2017 11:35 am
by w-u-2-o
All:
Watch this space for posting of the new version of the new protocol (protocol 2) firmware Simon has:
https://github.com/TAPR/OpenHPSDR-Firmware/tree/master/Protocol2Not sure when it'll post, but that's where it should go when it does.
73,
Scott
Re: New Protocol
Posted: Mon Apr 17, 2017 11:37 am
by Tony EI7BMB
watching with baited breath
Re: New Protocol
Posted: Mon Apr 17, 2017 10:14 pm
by gi4fue
Ditto, waiting for protocol for the 100, not B or D or E lol
Charlie GI4FUE
Re: New Protocol
Posted: Wed Jan 30, 2019 3:06 am
by w4cm
I have a Anan 7000. I am using v3.0.3, Sept. 11,2018 release. Is this the one I should use ?
Having crash issues. Also can not figure out how to use VOX. Can not get the mike to work on line in. Drive adjustment goes over 100 watts.
Thanks,
Cecil, W4CM
Re: New Protocol
Posted: Wed Jan 30, 2019 12:58 pm
by W1AEX
Hi Cecil,
Simon just released v3.0.4 which has many ANAN functions cleaned up. Install it right over your 3.0.3 and things should run much more smoothly.
https://www.sdr-radio.com/Software/%F0%9F%92%BEDownloads73,
Rob W1AEX
Re: New Protocol
Posted: Wed Jan 30, 2019 3:27 pm
by w4cm
Rob thanks. I did find the update and it does run MUCH smoother.