7000DLE MKIII - Stopped Receiving or Transmitting
Posted: Sat May 27, 2023 5:46 pm
Today, I was perusing the Thetis menus...2.9.0.31. I clicked the box titled "receive only". When I went to unclick the box, I got a warning that doing so might damage the ANAN hardware. "Scary" indeed. But I had no other choice. Thereafter, Thetis booted up normally. All the buttons worked normally. I could monitor my voice. Two tone displays on the screen. However, it quickly became apparent that there was no receive and no transmit power out. The thesis power meter did indicate power output of about 800 mW. I reinstalled Thetis v2.9.0.31 with no change.
What else can I do? Perhaps a reinstall of Protocol 1 firmware?
I purchased it and received it in late January 2023. It should be under warranty.
Thanks to all.
73 Torrey N9PY
PS: reinstalled Protocol 1 firmware...no change.
What else can I do? Perhaps a reinstall of Protocol 1 firmware?
I purchased it and received it in late January 2023. It should be under warranty.
Thanks to all.
73 Torrey N9PY
PS: reinstalled Protocol 1 firmware...no change.