Hi,
I am helping a friend to reinstall Thetis. We want to avoid importing the old database. His old Thetis version was RX level calibrated. Unfortunately I forgot my signal generator at home to do a level calibration.
Where in the database is the RX level calibration stored.
I want to copy this data to the new database.
thx
Sigi
how to copy RX level calibration data to a new database
how to copy RX level calibration data to a new database
73 de Sigi / DH1KLM
Re: how to copy RX level calibration data to a new database
Sigi--I just looked in my database and I can't say for certain, but if you search for the following string, "_cal_" (without the quotes), then those might be the values you want. Perhaps if you compare them to what's in the new database that might be some additional confirmation.
Re: how to copy RX level calibration data to a new database
Thanks Scott,
Through a comparison I found the following keys to be responsible for the "RX Level Calibration".
Simply copy the whole <Value> line and paste them into the new database.
<Key>rx_meter_cal_offset_by_radio</Key>
<Value>0.9800|... etc
and also
<Key>rx_display_cal_offset_by_radio</Key>
<Value>-2.1000|... etc
Through a comparison I found the following keys to be responsible for the "RX Level Calibration".
Simply copy the whole <Value> line and paste them into the new database.
<Key>rx_meter_cal_offset_by_radio</Key>
<Value>0.9800|... etc
and also
<Key>rx_display_cal_offset_by_radio</Key>
<Value>-2.1000|... etc
73 de Sigi / DH1KLM