Anyone see "ADC1 Overload" on TX?

[AB5N]

Hi guys-
Does anyone else get a "ADC1 Overload" warning during digital transmission? I'm running Protocol 2 with a DLEII.
Running VoiceMeeter to route TX monitor audio to speakers. ALC is -2. Signal is clean. Only if I reduce VAC 1 TX Gain
to where it is about 10 W output- does the warning go away. I'm baffled. Just checked and it goes away if I close VoiceMeeter.

Thanks- Bob-AB5N

[w-u-2-o]

Did it just start doing this, or has it always done it?

Are you running PureSignal?

What is your receive attenuator setting going to during TX?

[AB5N]

It never occurred again! IF it does... I'll collect data. Tnx Bob

[JJ4SDR]

Hi guys-
Does anyone else get a "ADC1 Overload" warning during digital transmission? I'm running Protocol 2 with a DLEII.
Running VoiceMeeter to route TX monitor audio to speakers. ALC is -2. Signal is clean. Only if I reduce VAC 1 TX Gain
to where it is about 10 W output- does the warning go away. I'm baffled. Just checked and it goes away if I close VoiceMeeter.

Thanks- Bob-AB5N

I saw ADC1 overload only today. Running Thetis 2.8.11 (10/20/209) /P1 with my Anan 7000 DLE MKII. Haven't changed any parameter settings for weeks and I am seeing the "ADC1 overload" in yellow color while monitoring 20 meters, not transmitting at all. I did use the SPLIT feature to work S9OK on 20 m SSB for a while. Only after using the SPLIT feature did I start seeing this overload message.

Puzzled!

Juha
NI2M