I attempted to update the G2, and upon booting a piHPSDR- Discovery message indicates that no local devices are found.
This appears to be a software or a hardware issue with the PCI Express interface, the FPGA, or even the R-Pi itself.
Any ideas how to remedy this?
73,
Tem
WT4DX
G2- No Local Devices Found
G2- No Local Devices Found
Last edited by WT4DX on Fri Jul 12, 2024 7:30 pm, edited 2 times in total.
Re: G2- No Local Devices Found
Also, when I execute git pull this is the result.
Re: G2- No Local Devices Found
Do you have a Github account set up? That might be part of your problem.
James
WD5GWY
James
WD5GWY
Re: G2- No Local Devices Found
Hi James,
I do have an active GitHub account.
73,
Tem
WT4DX
I do have an active GitHub account.
73,
Tem
WT4DX
Re: G2- No Local Devices Found
WT4DX wrote:Hi James,
I do have an active GitHub account.
73,
Tem
WT4DX
Ok, from looking at the display in your post it appeared that Github didn't find your email address that is registered with your account.
Maybe, it is how you typed in the command for Git pull. I have had a similar problem in the past trying to update PiHPSDR in my V1 controller. The Linux Command line isn't very forgiving!
Have you updated your G2 before?
James
WD5GWY
Re: G2- No Local Devices Found
WT4DX wrote:Also, when I execute git pull this is the result.
IMG_7056.jpg
check out this for setting your email info
viewtopic.php?f=48&t=4772#p26152
Good luck 73 John
Re: G2- No Local Devices Found
I have been getting the latest updates from: /github/dl1ycf/pihpsdr
John
N2KBE
John
N2KBE
Re: G2- No Local Devices Found
Apache Labs emailed me the G2 Display image, all is well, and the software is updated.
Sadly, I haven't even used the radio yet, and I've owned it for some time. Too many other irons in the fire.
73,
Tem
WT4DX
Sadly, I haven't even used the radio yet, and I've owned it for some time. Too many other irons in the fire.
73,
Tem
WT4DX