Woo-Hoo,
I've been testing the new firmware (not publicly available) and had a long QSO on 80m using VOX which was hammering the areas where before there had been issues.
it ran very nicely .
New Protocol
New Protocol
- Attachments
-
- Screenshot-2017-04-17-090330.png (1.55 MiB) Viewed 16164 times
sdr-radio.com
Re: New Protocol
All:
Watch this space for posting of the new version of the new protocol (protocol 2) firmware Simon has:
https://github.com/TAPR/OpenHPSDR-Firmware/tree/master/Protocol2
Not sure when it'll post, but that's where it should go when it does.
73,
Scott
Watch this space for posting of the new version of the new protocol (protocol 2) firmware Simon has:
https://github.com/TAPR/OpenHPSDR-Firmware/tree/master/Protocol2
Not sure when it'll post, but that's where it should go when it does.
73,
Scott
- Tony EI7BMB
- Posts: 653
- Joined: Sun Apr 09, 2017 2:31 pm
- Location: Dublin
- Contact:
Re: New Protocol
watching with baited breath
Re: New Protocol
Ditto, waiting for protocol for the 100, not B or D or E lol
Charlie GI4FUE
Charlie GI4FUE
Re: New Protocol
I have a Anan 7000. I am using v3.0.3, Sept. 11,2018 release. Is this the one I should use ?
Having crash issues. Also can not figure out how to use VOX. Can not get the mike to work on line in. Drive adjustment goes over 100 watts.
Thanks,
Cecil, W4CM
Having crash issues. Also can not figure out how to use VOX. Can not get the mike to work on line in. Drive adjustment goes over 100 watts.
Thanks,
Cecil, W4CM
Re: New Protocol
Hi Cecil,
Simon just released v3.0.4 which has many ANAN functions cleaned up. Install it right over your 3.0.3 and things should run much more smoothly.
https://www.sdr-radio.com/Software/%F0%9F%92%BEDownloads
73,
Rob W1AEX
Simon just released v3.0.4 which has many ANAN functions cleaned up. Install it right over your 3.0.3 and things should run much more smoothly.
https://www.sdr-radio.com/Software/%F0%9F%92%BEDownloads
73,
Rob W1AEX
"One thing I am certain of is that there is too much certainty in the world."
Re: New Protocol
Rob thanks. I did find the update and it does run MUCH smoother.
Last edited by w4cm on Thu Jan 31, 2019 1:04 pm, edited 1 time in total.