Apache Labs Community Forum

ramdor wrote:

vk1hx wrote: All good Richie, thanks for confirming it wasn't something I missed . I rolled back to Thetis 2.10.3.6_dev2 and TX was the same as 2.10.3.5u2.

I have updated the post, a few posts up, with wip_5. This is now fixed. Please give it a test run if you have a moment. That was a very good spot

Have downloaded the update and will install and report back shortly.

Thank you!

Hi Richie,

That issue is now resolved. Thank you.
There is also some artifact at the bottom of the setup box. see image where red circle is.

Hi Richie,

Thanks for adding .bat support. I was simply going to change it to a .cmd file, but you beat me to it!

Your latest YT video popped up on my feed:



The current meter container paradigm is very "column oriented". Would there be any chance of allowing multiple columns in a single container? For instance, instead of 5 containers (including the empty spacer containers at either end) to get this, you could do it in a single container:

Cheers!

Scott

Anyone seen this?
Started once OK then this.

try dev_6 wip_5. This should be resolved. Link in this post.....

viewtopic.php?f=9&t=5121&start=30#p29907

@scott. There is quite a bit of reliance on the column orientation right now, and would take a fair bit of conversion to allow multi column. Also due to the vertical nature of the configuration setup list boxes they map directly to the positions in the view.

Never say never and all that but it is not something I have thought about too much. I would perhaps be interested in looking at coding up a different type of container, which is say a container of containers, and those sub containers could be positioned in any x/y grid layout.

R.

dev_6 released now. I have just started a new thread for it. Head over there if you find anything Thanks all.