Apache Labs Community Forum

So, ive been noticing this for quite some time now, but I don't use the memories much so It wasn't a big deal. However, i'm getting back into SSB more so switching TX profiles and not having the drive levels save per TX profile, but per band, is becoming an issue for me. When I switch modes and TX profiles, I forget to lower the drive when I go back to AM...

Anyway, to the original reason i'm writing this. I want to use the memories because they save drive level. However when I click on the memory tab, 90% of the time (not all the time which is weird) it automatically goes to the first memory stored as soon as I open the "Memory" window. I was due for a database reset after 7 months, so I tried it and still the same issue. I went ahead and did a fresh install of 2.7.0a3 and uploaded a fresh download of the 1.9 Orion firmware for my 200d..

Ive asked 3 others about this and they don't have this issue... Is there a setting I have missed somewhere?


Oh and im using a 200d, 2.7.0a3, p2v1.9...


Thanks!!
Perry

Mine does the same thing here too, it's really annoying! For some reason I had the first memory set to 10 meters (must have been playing around)---now every time I click on the memory tab the radio changes to that 10 meter frequency.

Larry N7ZDR

LarryW wrote:Mine does the same thing here too, it's really annoying! For some reason I had the first memory set to 10 meters (must have been playing around)---now every time I click on the memory tab the radio changes to that 10 meter frequency.

Larry N7ZDR

What software version are you running?

Sorry---- I am using Thetis v2.7.0 (3/1/20) with the 7000 mkll.

Regards,
Larry

LarryW wrote:Sorry---- I am using Thetis v2.7.0 (3/1/20) with the 7000 mkll.

Regards,
Larry

Me too, 2.7.0(A3) and a 200D. I know a couple gentleman running 2.6.9 still and have no issues. Who knows, it is what it is lol.