Apache Labs Community Forum

Posted: **Thu Oct 15, 2020 5:14 pm**

Hello. Hope this is the right place to report these... Let me know.

Running 2.8.9 with P2
Assuming firmware is 2.0 and not 2.0b ? The setup-general-HWselect screen shows ver 2.0 Right above the OrionMkII ID
Received the -ve icon (yellow triangle inside red box) in status bar. Clicked and below is the text:

Code: Select all

DCC0
s0=0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2601234 -2601235 0 0 0 0 0 0 0 0 0 0  r:161109 l:2762343 10/15 12:41:21:468
s1=0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2601234 0 0 0 0 0 0 0 0 0 0 0  r:2762343 l:161108 10/15 12:38:30:489

DCC0
s0=0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2601234 0 0 0 0 0 0 0 0 0 0 0  r:2762343 l:161108 10/15 12:38:30:489

DCC2
s0=0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 154 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0  r:667018 l:666863 10/15 12:16:51:819

Posted: **Thu Oct 15, 2020 5:25 pm**

There is no longer any need to report on seq errors or out of order packets. As far as anyone can determine, the UDP protocol stack is as optimized as it can be. UDP is a lossy protocol, and the Windows UDP protocol stack sometimes gets weird about things, too. There will always be a low error rate.

I've turned off the seq error reporting feature in the settings myself.

Apache Labs Community Forum

Out of sequence packets... Received the -ve icon

Out of sequence packets... Received the -ve icon

Re: Out of sequence packets... Received the -ve icon