Apache Labs Community Forum

In an earlier installation of Thetis, after I installed Protocol 2, I found a setting that allowed me to see the entire 40 meter band in one screen, when zoomed in all the way. If memory serves, I think I could see the entire spread of the 20M band as well. I would like to go back to that state, but for the life of me, I can't remember what setting I changed to make those wide spreads possible. Any ideas?

Richard (JP)
K5JPP

If you change your sample rate to 768 kHz then you will be able to see most of the HF bands in their entirety.

Thank you. There is so much to know about Thetis and so many ways to get lost in it, especially for those of us unschooled in the ways of IT. It's always an adventure. Know that you efforts to help are greatly appreciated.

Richard (JP)
K5JPP