Page 1 of 1
Thetis software
Posted: Wed May 28, 2025 11:29 pm
by vk2je
Being a relative new operator to thetis only 2 years I am trying to establish how to toggle on the numbers beside the cursor when in TX mode to enable me to see what my IMD levels are, please see attached jpeg from a friends screenshot.
Any assistance greatly appreciated. I am using Thetis 2.10.3.6X64 dev_2
my anan is a 7000 MK11 DLE
Thanks for reading, Brian
Re: Thetis software
Posted: Thu May 29, 2025 2:02 am
by K1LSB
Brian,
I'm not really clear on what you're asking, because your friend's screenshot doesn't have any numbers beside the cursor.
Regardless, here's where to toggle the numbers I believe you're asking about.
Mark
- Capture.jpg (111.83 KiB) Viewed 1293 times
Re: Thetis software
Posted: Thu May 29, 2025 5:34 am
by vk2je
Hi Mark, thanks for reply, the No's I am referring to start at top 5 and finish at bottom -75 to the right hand side of vertical cursor in tx mode
tried toggling on the show additional and no did not change anything.
Brian
Re: Thetis software
Posted: Thu May 29, 2025 10:38 am
by K1LSB
Here ya go.
- Capture.jpg (82.45 KiB) Viewed 1260 times
Mark
Re: Thetis software
Posted: Thu May 29, 2025 11:35 pm
by vk2je
Thank you so much problem solved.
Brian
