ANAN-7000DLE MKII NUC I7 (Silver Face) ribbon cable connections

[kharaburda]

I heard rattle inside my ANAN 7000DLE MKII NUC I7. I took it apart and found a small washer in one of the "dimples" in the huge aluminum heat sink.

I disconnected a few of the ribbon cables in the process. The connection points on the ORION board seemed obvious. But when I went to reattached the last ribbon cable I sadly noticed there were 2 identical header located right next to each other. Oops !!

I hope someone can tell me which header to use.

Thanks

Kent (KG5UWB)

IMG_2943_hilite-min 3.JPG (529.99 KiB) Viewed 4866 times

[n1gp]

Hi Kent,

It should go to the upper one closest to the metal case, P1.

-Rick / N1GP

[kharaburda]

I am back on the air.

Thank you Rick (N1GP)

[Tony EI7BMB]

I found the off cut of a plastic cable tie in my 7000