Upgrading PS from 1 to 2....

[Bill in Georgia]

Just installed 3.3.15, in my 200D, and I see there have been changes in Pure Signal, read WA!OXT's epistle on Pure Signal 2.0 ... and before I get to far down the road, am wondering if the mechanical lash-up is the same as #1... in other words use of the coupler/Dummy Load/Pad. etc.
Thanks

Bill - KC4PE

[w-u-2-o]

Yes, the feedback paths, methods and levels all remain the same.

73,

Scott

[Bill in Georgia]

Thanks..

[N9VX]

Where do I find this document? " read WA!OXT's epistle on Pure Signal 2.0 " I am trying to setup PureSignal 2.0 with internal crosstalk and see how it works, and then graduate to external coupler.

Joe N9VX

[w-u-2-o]

Where do I find this document? " read WA!OXT's epistle on Pure Signal 2.0 " I am trying to setup PureSignal 2.0 with internal crosstalk and see how it works, and then graduate to external coupler.

Joe N9VX

Not sure what that is, but I just posted the PureSignal 2.0 release notes in this subforum:

https://apache-labs.com/community/viewt ... =20&t=2409