Problem fixed!
It seems the firmware was corrupted.
Re-uploading the software to the Arduino board the VFO encoder began to work.
Here is the last version of Arduino S/W:

https://github.com/laurencebarker/SaturnG2V2_Front_Panel

73 Jose

Hello,

Today I found a problem on my G2 Ultra, the dial stopped working, the rest of the knobs and buttons on the panel work perfectly.
The problem occurs in both, Thetis with p2app and pihpsdr.
First step, I have tried to update p2app, pihpsdr, reflashing FPGA without success.
I don't have the ...

This might help you:

https://community.apache-labs.com/viewtopic.php?f=48&t=5176

73 Jose

I received my Anan G2 Ultra around 2 months ago, and the same old version. Moreover in my case the front knobs didn't work with the last Thetis version. I did the upgrade to the last version and the front knobs began to work.

Here I explained my case:

https://community.apache-labs.com/viewtopic ...

Thank you Laurence for the suggestions, I fixed the issue. I have the G2 Ultra only one week ago, and it cames with the last P2app version V27 which is the current last version.
I forced the upgrade and downloaded again the V27, now the front panel is detected and works fine with Thetis.
If someone ...

Hello,

I received the G2 Ultra a few days ago. I'm trying running Thetis getting the panel front knobs control of the G2 but it doesn't work.
Acording the last manual I run "p2app -p" and in Thetis is set on the TCP/IP CAT computer IP, port 13013, and in Andromeda tab enables G2 Panel.

When I run ...

Hi!
I'm using the multimeter with the LP100A Bridge, and it is running very well.
As now it is possible to read the power of the amplifiers on the multimeter, could the upper limit of the power scale be changed i.e. to 4.000?, now the limit is 2500.
Useful for testing some amps

73 Jose

WANTWISH

Hi Richie,

First, many thank for your effort with amainzing improvements in this software.
I have a wish to improve the current RIT/XIT method. When I try adjust the freq. of some operators a bit shifted it seems me a bit uncomfortable of use with the small arrows up/down and mouse when ...