Unreadable receive display on mox

[iw7dmh]

Hello,

I would like to view the transmitted signal in the panadapter, mostly when I am working in split.
I enabled the DUP and MultiRX functions but the signal shown is actually huge, about 60 KHz, as you can see in the picture below.
I am wondering if i am missing some config parameter or there is a way to reduce the TX signal bandwidth.

TX.jpg (192.39 KiB) Viewed 2712 times

display tx settings.jpg (49.51 KiB) Viewed 2712 times

[w-u-2-o]

Change the TX Grid Scale to max 15, min -17, step as desired.

Change the waterfall low level to -70, and the high level to -20.

Any energy below -70 is simply a "don't care", no one will ever see it or hear it.

[iw7dmh]

Change the TX Grid Scale to max 15, min -17, step as desired.

Change the waterfall low level to -70, and the high level to -20.

Any energy below -70 is simply a "don't care", no one will ever see it or hear it.

Thank you very much dr Scott,
now it is far better.

73' Enzo
iw7dmh