N4QNT wrote:Joe, how do you keep the Two meters alway open in Receive, I have a blank window, but when I transmit the TX meter appears??
Thanks
I did nothing special - did not configure anything - just used the default Meters (directory Richie provided) which is sitting on same level as Skins directory.
I "sized" the meters and dragged them into a non-active (no signals) part of the panadaptor screen display.
Obviously the "meters" are NOT Expanded and have focus INSIDE the active Thetis window. <<<<<
THIS IS PROBABLY MOST LIKELY WHY YOURS DISAPPEAR
Some other comments - I "run" my Thetis.EXE (which I compiled) code from the bin>x86>Debug directory because I did not want to "zap" my working Thetis directory with my experimentation compilations and testing code. I also loaded a saved copy of my “working” (2.9.0.6) database.
I still have not fully explored the Meters code - just wanted to let Richie know - that no problem to compile and that "it works" out of the box so to speak.
I noticed that my frame rate (set to 50) normally has absolutely no problem with the "release" version of Thetis (2.9.0.6) - no warning "red dot"
With the pre-release code I compiled (2.9.0.7) - I noticed the same frame rate (still 50) is now exhibiting the "red dot" telling me it can’t maintain the 50 FPS.
I guess this is probably one of the reasons why Thetis is high CPU% now - something to do with the graphics code.
Please Note: I am only using the Intel UHD Graphics 630 which is built -in on the i3-8100 CPU (3.6GHz) which is my system.
Your comment about no PS glitches and SEQ errors ... I can confirm that they are directly correlated to the quality and BW of your network connection with the PC and Anan radio.
As I was stressing my network on the PC - approaching 100Mbps - while Thetis was running - I could see some SEQ errors popping up - just a few - but they only did this when the network was under stress - otherwise I just don't get any SEQ errors. (I believe others have also confirmed – poor network = SEQ errors)
BTW - My working environment is Windows 11 Pro 21H2
I also noticed you have different HW to me (100D) and obviously the F/W is also different.
At this stage I am not sure if this has any bearing on the Meters "code" / function.
My compile reveals a "button TS2" - I cannot move this - I presumed this is temp code Richie put in to "reset meters" to known location within the window - as this is the current behavior OR my compilation went wrong somwhere - despite no warnings
Hope the above comments are useful
Cheers
