When I transmit CW with my Angelia board, I don't see any CW waveform (or anything else) on the panadapter. During TX, the TX panadapter is blank except for the grid. I do see the waveform nicely for Digital modes. I have searched throughout the Thetis setup screens and I don't find anything specific for the CW display. Setup/Display/TX/TX grid scale is -200 minimum. Any suggestions what I might do?
Thanks,
W9IP
CW TX waveform display
Re: CW TX waveform display
Is DUP on or off? If DUP is on, then is your Angelia board connected to RF components that provide the necessary full duplex feedback during transmit?
Re: CW TX waveform display
I can turn on DUP and see what the RX is detecting. This is different from the TX waveform that I am asking about. The other modes display TX waveform. For example, during a Digi transmission, you can watch the TX output dance around in frequency while you're transmitting. I just can't get the panadapter to show it for CW.
W9IP
W9IP